Cyrix-Li-Charge 24/48V 230A Intelligent Charge Relay

Features of the - Cyrix-Li-Charge 24/48V 230A Intelligent Charge Relay

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay: - if the Charge Disconnect output of the VE.Bus BMS is high, and - if it senses 13,7V (resp. 27,4V or 54,8V) or more on its battery charger connection terminal, and - if it senses 2V or more on its battery terminal (the Cyrix will remain open, if not connect to the battery).

The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature.

In general a cell over voltage alarm will reset shortly after charging has been stopped. The Cyrix will then reconnect the charger after a delay of 3 seconds. After two attempts to re-engage with 3 seconds delay, the delay increases to 10 minutes.

Whenever battery voltage is less than 13,5V (resp. 27V or 54V), the Cyrix will disengage with a delay of 1 hour. Note 1: In case of zero discharge current, or a small discharge current, the Cyrix will not disengage shortly after the charger has been switched off and/or disconnected, because battery voltage will remain higher than 13,5V. Note 2: If, after the Cyrix has disengaged, the output of the battery charger immediately increases to 13,7V or more, the Cyrix will re-engage, with 3 seconds delay.

PRODUCT CODE: CYR020230430